Mercruiser Tools

This alignment tool slides inside the transom assembly to check the alignment between the engine and Sterndrive. Engine alignment should be carried out each year to protect the Gimball bearing and Sterndrive UJ.

The driver rod, part number 91-37323 is used with various drivers to install bearings on Alpha One Gen 2 and Bravo One and Two gearcases.

Used to install Gimbal bearings on Alpha One Gen 2 and Bravo One and Two gear cases.

This Gimbal bearing driver tool, part number 91-32325Tis used to install Gimbal bearings on Alpha One Gen 2 and Bravo One and Two gear cases.

This Mercruiser Gimbal slide hammer removal tool removes the Gimbal bearing and bearing cups.

This kit removes and installs bearings on all gear cases including MC-I, R-MR, Alpha One, Alpha One Gen Two and Bravo Sterndrives

Hinge Pin Tool for Alpha One Gen 2, Gen 1 and Bravo drives. The hinge pin tool is required for the removal of the hinge pins in all Mercruiser drives.

This bellows expander tool is required to fit the exhaust bellows on Alpha One Gen 2 outdrives from 1998 onwards. Its also required on MC-1, R, MR and Alpha One drives.

This shift cable tool installs and removes the shift cable into the bell housing of the transom assembly on Alpha One Gen 2 drives.

This is a genuine service manual for the Alpha One Gen II Sterndrive.

The Mercruiser and Mariner/Mercury oil drain pump attaches to the threaded fitting on the top of the dipstick and pumps oil from the engine crankcase.